Clark is a wood-look SPC floor built around a warm light beige color, with a durable, heavy-traffic wear layer for a low-maintenance, practical finish.

Yes — 100% waterproof. A splash at the sink or a dropped glass wipes up without harming Clark when cleaned promptly; don't leave water standing. Indoor use only — outdoor installation is not approved.

Clark is protected by a 20 mil wear layer — about 0.51 mm — built for heavy residential use and many light-commercial applications, delivering excellent protection against everyday scratches, scuffs, and abrasion. It sits at the thicker, harder-wearing end of the range.

Clark has a 20 mil protective layer — thicker than the thin wear layers on entry-level LVT. That's the physical protective film above the print, sealed by finish.

Up close, Clark shows a long straight grain with pronounced cathedral centers rising down the middle of each board. Looping eye-shaped figure and small clustered eye knots scatter across the printed surface at a moderate density, adding quiet character rather than heavy rustic markings. The print shifts enough from board to board that the repeat never shows.

The EVA acoustic layer damps the hollow "click" sound characteristic of floating floors. Clark is quieter underfoot than LVT with a loose pad — both for the walker and for rooms below in multi-story homes.

Clark is a versatile warm neutral that leans light without going cold. Under bright, window-lit daylight it lifts toward a clean warm beige; in softer or lower light the honey-tan undertone comes forward and warms the room. That easy shift makes Clark a comfortable match for both cool grey walls and warmer wood-tone furniture.